LETTERPRESS MAGNETIC PLATEN & ROLLER ADJUSTMENT GAUGES 2 IN 1 NEW PRINTING TOOL

Description

HERE'S A LETTERPRESS MAGNETIC PLATEN & ROLLER ADJUSTMENT GAUGES 2 IN 1 NEW PRINTING TOOL
We have just developed this tool. The set of four gauges will work for setting the platen adjustment of almost any platen press in existance from a table top press, such as a Kelsey or Pilot to huge floor model C&P or Kluge. (The magnets will not stick to a press with a nonferrous bed such as aluminum, but they work well on steel or cast iron as most presses are.)
The gauges are made of finely machined aluminum so they will not rust and the magnets are strong rare earth mangnets!
Simple to use!
Remove tympan paper and all packing
Place one gauge at each corner of the type bed
Back off on the impression adjustment
Close the press
Put the press ON IMPRESSION if it has an impression control
Then simply turn the adjustment nuts or bolts until the platen is level to the gauge at each corner
Secure the adjustment locknuts etc
The platen will now be adjusted to .040 OVER TYPE HIGH
Now reinstall your tympan paper and adjust the packing
Now for the two in one part ......
One of the gauges has a threaded hole in the side
Screw the INCLUDED 12 inch handle into the hole and you have a lollypop tool for checking the height of your rollers as in the photos.
The dimesion of the round diameter of the gauge is precisely type high!!
Please call Rick at 706 540-3285 noon to midnite eastern time if you have questions about a purchase or using the tool. Thanks.